Power Distribution Board; Removing The Power Distribution Board - Dell PowerEdge T610 Hardware Owner's Manual

Power Distribution Board

Removing the Power Distribution Board

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet and peripherals.
2 Remove the power supplies. See "Removing a Power Supply."
3 Open the system. See "Opening the System."
4 Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
5 Remove the cooling shroud. See "Removing the Cooling Shroud."
6 Disconnect the cables from the following connectors on the power
distribution board (see Figure 6-3):
• J_DVD_TAPE_PWR
• J_BP_PWR
• J_BB_PWR1
• J_BB_PWR2
• J_BB_SIG
If you intend to replace the power distribution board, leave the cables
attached to the system board, SAS backplane, and optional optical or tape
drives.
7 Pull and hold the blue release pin, and slide the board upwards. Pull the
board assembly away from the chassis until the securing slots are free from
the tabs in the chassis, and lift the board out of the chassis. See
Figure 3-26.
146
Installing System Components
Many repairs may only be done by a certified service technician. You