Embedded Server Management Screen - Dell PowerEdge T610 Hardware Owner's Manual

Option
Serial Port Address
(Serial Device 1=COM1,
Serial Device2=COM2
default)
External Serial Connector
Failsafe Baud Rate
(115200 default)
Remote Terminal Type
(VT100/VT220 default)
Redirection After Boot
(Enabled default)

Embedded Server Management Screen

Option
Front Panel LCD Options Options are User Defined String, Model Number, or
User-Defined LCD String You can enter a name or other identifier for the system, to
66
Using the System Setup Program and UEFI Boot Manager
Description
Sets the serial port addresses for the two serial devices.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). To use console redirection by SOL, configure
the same port address for console redirection and the
serial device.
Specifies whether COM1, COM2, or Remote Access
Device has access to the external serial connector.
NOTE:
Only Serial Device 2 can be used for Serial Over
LAN (SOL). Configuring the external serial connector to
Serial Device 1 allows independent use of Serial Device 1
while Serial Device 2 can be used for SOL.
Displays the failsafe baud rate used for console
redirection. BIOS attempts to determine the baud rate
automatically. This failsafe baud rate is used only if the
attempt fails. This rate should not be adjusted.
Sets the remote console's terminal type. Select either
VT100/VT220 or ANSI.
Enables or disables BIOS console redirection after the
operating system boots.
Description
None.
If the LCD Home screen is set to an option other than
these three choices, the option will be displayed as
"Advanced" in the BIOS. In this event, the option cannot
be changed in the BIOS unless it is changed back to User
Defined String, Model Number, or None through
another LCD configuration utility (such as the iDRAC
Configuration Utility or the LCD panel menu).
be displayed on the LCD module screen.