Dell PowerEdge T610 Hardware Owner's Manual page 26

Table 1-1. LCD Status Messages (continued)
Code Text
E1116 Memory
disabled, temp
above range.
Power cycle
AC.
E1210 Motherboard
battery
failure. Check
battery.
E1211 RAID
Controller
battery
failure. Check
battery.
E1216 3.3V Regulator
failure.
Reseat PCIe
cards.
E1229 CPU # VCORE
Regulator
failure.
Reseat CPU.
E122A CPU # VTT
Regulator
failure.
Reseat CPU.
26
About Your System
Causes
Memory has exceeded
allowable temperature and
has been disabled to
prevent damage to the
components.
CMOS battery is missing
or the voltage is outside of
the allowable range.
RAID battery is either
missing, bad, or unable to
recharge due to thermal
issues.
3.3V voltage regulator has
failed.
Specified processor
VCORE voltage regulator
has failed.
Specified processor VTT
voltage regulator has
failed.
Corrective Actions
Remove AC power to the
system for 10 seconds and
restart the system.
See "Troubleshooting
System Cooling
Problems." If the problem
persists, see "Getting
Help."
See "Troubleshooting the
System Battery."
Reseat the RAID battery
connector. See "Installing
a RAID Battery", and
"Troubleshooting System
Cooling Problems."
Remove and reseat the
PCIe expansion cards. If
the problem persists, see
"Troubleshooting
Expansion Cards."
Reseat the processor(s).
See "Troubleshooting the
Processor(s)".
If the problem persists,
see "Getting Help."
Reseat the processor(s).
See "Troubleshooting the
Processor(s)".
If the problem persists,
see "Getting Help."