Figure 91. Installing a 1.8 inch hot-swappable uSATA SSD carrier
a. release button
b. SSD carrier
c. SSD carrier handle
Related tasks
Removing a 3.5-inch hard drive blank
Removing a 2.5-inch hard drive blank
Installing a hard drive or solid state drives into a hard drive carrier
Installing the hard drive backplane
Removing a hard drive or a solid state drive from a hard drive
carrier
Prerequisites
1. Keep the Phillips #1 screwdriver ready.
2. Remove the hot swappable hard drive carrier from the system.
Steps
1. Remove the screws from the slide rails on the hard drive carrier.
2. Lift the hard drive out of the hard drive carrier.
Figure 92. Removing a hard drive from a hard drive carrier
a. screw (4)
b. hard drive
c. hard drive carrier
on page 151
on page 149
on page 166
on page 156
Installing and removing system components
155