Removing A Cooling-Fan Module - Dell PowerEdge T610 Hardware Owner's Manual

Removing a Cooling-Fan Module

WARNING:
has been powered down. Allow time for the fans to stop spinning before handling
them.
CAUTION:
in the cooling shroud's outer fan-module slot (see Figure 3-10) at all times to
ensure proper system cooling.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and peripherals.
2 Open the system. See "Opening the System."
3 Remove the expansion card stabilizer. See "Removing the Expansion Card
Stabilizer."
4 Remove the cooling shroud (see "Removing the Cooling Shroud") and
turn the shroud upside-down.
5 Press the fan-module release tabs towards each other, and slide the module
up and out of the cooling shroud. See Figure 3-10.
94
Installing System Components
The cooling fans can continue to spin for some time after the system
The system requires at minimum a cooling-fan module to be installed