Dell PowerEdge T610 Hardware Owner's Manual page 27

Table 1-1. LCD Status Messages (continued)
Code Text
E122C CPU Power
Fault. Power
cycle AC.
E122D Memory
Regulator #
Failed. Reseat
DIMMs.
E122E On-board
regulator
failed. Call
support.
E1310 Fan ## RPM
exceeding
range. Check
fan.
E1311 Fan module ##
RPM exceeding
range. Check
fan.
E1313 Fan redundancy
lost. Check
fans.
E1410 System Fatal
Error
detected.
Causes
A power fault was
detected when powering
up the processor(s).
One of the memory
regulators has failed.
One of the on-board
voltage regulators failed.
RPM of specified fan is
outside of the intended
operating range.
RPM of specified fan in
specified module is
outside of intended
operating range.
The system is no longer
fan redundant. Another
fan failure would put the
system at risk of over-
heating.
A fatal system error has
been detected.
Corrective Actions
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help."
Reseat the memory
modules. See
"Troubleshooting System
Memory."
Remove AC power to the
system for 10 seconds and
restart the system.
If the problem persists,
see "Getting Help."
See "Troubleshooting
System Cooling
Problems."
See "Troubleshooting
System Cooling
Problems."
Check LCD for
additional scrolling
messages. See
"Troubleshooting a Fan."
Check LCD for
additional scrolling
messages. Remove AC
power to the system for
10 seconds and restart the
system.
If the problem persists,
see "Getting Help."
About Your System
27