Installing The Power Distribution Board - Dell PowerEdge T610 Hardware Owner's Manual

Figure 3-26. Removing and Installing the Power Distribution Board
1
1 release pin
3 securing slots

Installing the Power Distribution Board

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Position the power distribution board so that the tabs in the chassis are
fully inserted into the securing slots on the back of the board assembly. See
Figure 3-26.
2 Slide the board downwards until the blue release pin locks into place.
3 Connect the five cables to the following connectors on the power
distribution board (see Figure 6-3):
• J_DVD_TAPE_PWR
2
3
4
2 power distribution board cables (5)
4 power distribution board assembly
Installing System Components
147