Installing A Raid Battery; Expansion Cards - Dell PowerEdge T610 Hardware Owner's Manual

Figure 3-18. Removing and Installing a RAID Battery
1 battery cable connector
3 battery carrier tabs (2)
5 battery carrier

Installing a RAID Battery

1 Insert the RAID battery into the battery carrier. See Figure 3-18.
2 Insert the battery carrier with the RAID battery into the battery carrier
slots until the carrier release latch locks into place. See Figure 3-18.
3 Connect the battery cable to the connector on the integrated storage card
(see Figure 3-17) and replace the integrated storage controller card. See
"Installing an Integrated Storage Controller Card."

Expansion Cards

The system board can accommodate up to five PCIe Generation 2 expansion
cards:
• Two full-height, full-length (12.2-inch) PCIe x8 link (slots 2 and 3)
118
Installing System Components
1
6
5
2
4
6
4
RAID battery
battery carrier slots (2)
battery carrier release tab
2
3