Installing A Hard-Drive Blank; Removing A Hot-Swap Hard Drive - Dell PowerEdge T610 Hardware Owner's Manual

Figure 3-4. Removing and Installing a Hard Drive Blank
1
3
1 3.5-in hard drive blank
3 release latch

Installing a Hard-Drive Blank

Align the hard-drive blank with the drive bay and insert the blank into the
drive bay until the release lever clicks into place.

Removing a Hot-Swap Hard Drive

CAUTION:
swap drive removal and installation. See the documentation provided with your
operating system for more information.
1 Remove the front bezel. See "Removing the Front Bezel."
2 From the RAID management software, prepare the drive for removal. Wait
until the hard-drive indicators on the hard-drive carrier signal that the
drive can be removed safely. See your controller documentation for
information about hot-swap drive removal.
84
Installing System Components
To prevent data loss, ensure that your operating system supports hot-
2
3
2 2.5-in hard drive blank