Installing Memory Modules - Dell PowerEdge R430 Owner's Manual

Steps
1. Locate the appropriate memory module socket.
2. To release the memory module from the socket, simultaneously press the ejectors on both ends of the memory module
socket.
3. Lift and remove the memory module from the system.
Figure 26. Removing the memory module
a. memory module
b. memory module socket
c. memory module socket ejector (2)
Next steps
1. Install the memory module.
If you are removing the memory module permanently, install a memory module blank.
NOTE:
2. Install the cooling shroud.
Related references
Safety instructions on page 71
Related tasks
Before working inside your system
Removing the cooling shroud

Installing memory modules

Installing the cooling shroud
After working inside your system
Installing memory modules
Steps
1. Locate the appropriate memory module socket.
2. Open the ejectors on the memory module socket outward to allow the memory module to be inserted into the socket.
3. Align the edge connector of the memory module with the alignment key of the memory module socket, and insert the
memory module in the socket.
88 Installing and removing system components
on page 72
on page 79
on page 88
on page 80
on page 72