Installing The Chassis Intrusion Switch; Power Supply Distribution Module; Removing The Power Supply Distribution Module - Dell PowerEdge HR675 Hardware Owner's Manual

Installing the Chassis Intrusion Switch

1 Align the chassis intrusion switch with the securing bracket notch (see
Figure 3-30).
2 Slide the switch into the securing bracket notch (see Figure 3-30).
3 Connect the switch cable to the INTRUSION connector on the system
board (see Figure 6-1).
4 Close the expansion card cover (see Figure 3-7).
5 Replace the system cover (see "Installing the System Cover" on page 67).

Power Supply Distribution Module

If your system has redundant power supplies, it will have a power supply
distribution module inside the system.

Removing the Power Supply Distribution Module

1 Turn off the system, including any attached peripherals, and disconnect
the system from the electrical outlet.
2 Remove the redundant power supplies (see "Removing a Redundant Power
Supply" on page 73).
3 Remove the system cover (see "Removing the System Cover" on page 66).
4 Remove the processor airflow shroud (see "Removing the Processor Airflow
Shroud" on page 70).
5 Disconnect all power supply distribution module power cables from the
system board. See Figure 3-31.
6 Pull and hold the blue release pin, slide the module up to free the securing
tabs from the slots, and lift the board out of the chassis (see Figure 3-31).
Installing System Components
123