Installing A Raid Battery; Remote Access Controller Card (Rac); Removing The Rac Card - Dell PowerEdge HR675 Hardware Owner's Manual

Installing a RAID Battery

1 Insert the RAID battery into the battery carrier (see Figure 3-21).
2 Insert the battery carrier and RAID battery into the system's battery carrier
slots, ensuring that the battery carrier is aligned and fully seated in the slots.
3 Connect the battery cable to the SAS/RAID controller card. See the
documentation for your card for more information.
4 Route the battery cable through the battery cable slot in the chassis (see
Figure 3-21).
5 Replace the system cover (see "Installing the System Cover" on page 67).

Remote Access Controller Card (RAC)

The optional Remote Access Controller card provides a set of advanced
features for managing the system remotely.

Removing the RAC Card

CAUTION:
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
2 Remove the system cover (see "Removing the System Cover" on page 66).
3 Open the expansion card cover (see Figure 3-7).
NOTE:
4 Open the expansion card latch adjacent to the slot (see Figure 3-20).
NOTICE:
metal ends of the cable connectors and gently work the connector out of the
socket. Do not pull on the cable to unseat the connector. Doing so can damage the
cable.
5 Disconnect the ribbon cable to the RAC card.
102
Installing System Components
Many repairs may only be done by a certified service technician. You
You can remove the expansion card cover, if desired, and set it aside.
When detaching the RAC cables from the system board, squeeze the