Raid Battery; Removing A Raid Battery - Dell PowerEdge HR675 Hardware Owner's Manual

NOTICE:
Do not route card cables over or behind the cards. Cables routed over the
cards can prevent the system cover from closing properly or cause damage to the
equipment.
9 Using the appropriate interface cable, connect the SAS controller card
(connector 0) directly to the internal hard drives or to the SAS backplane,
if installed.
NOTE:
the cable. The cable does not operate if reversed.
10 Connect the SAS cable, LED cable, and RAID battery cable (if applicable)
to the SAS controller card.
NOTE:
"Installing a RAID Battery" on page 102).
11 Close the expansion card cover (see Figure 3-7).
12 Replace the system cover (see "Installing the System Cover" on page 67).
13 Reattach any peripherals you disconnected, then connect the system to
the electrical outlet.
14 Turn on the system and attached peripherals.
15 Install any device drivers required for the card.
See the documentation for the card for information about installing the
card's device drivers.

RAID Battery

The information in this section applies only to systems with the optional
battery-cached SAS/RAID controller card.

Removing a RAID Battery

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
1 Turn off the system and attached peripherals, and disconnect the system
from the electrical outlet and from the peripherals.
The cable must be connected according to the connector labels on
For battery-cached SAS/RAID controllers, install the RAID battery (see
Installing System Components
99