Installing The Processor - Dell PowerEdge HR675 Hardware Owner's Manual

Installing the Processor

1 Unpack the new processor.
2 Ensure that the release lever on the processor socket is fully extended, or
in the up position (see Figure 3-28).
3 Align the processor with the socket keys on the ZIF socket (see
Figure 3-28).
NOTICE:
system board or the processor when you turn it on. When placing the processor in
the socket, be careful not to bend the pins in the socket. Avoid touching the socket
pins or the pads on the processor when handling the processor or the system
board.
NOTICE:
correctly, it engages easily into the socket.
4 With the processor and the socket keys aligned, set the processor lightly
in the socket.
5 When the processor is fully seated in the socket, close the processor cover
(see Figure 3-28).
6 Rotate the socket release lever back down until it snaps into place,
securing the processor (see Figure 3-28).
7 Install the heat sink.
NOTE:
that you removed from the old processor.
If you receive a heat sink and pre-applied thermal grease with your
a
processor kit, remove the protective sheet from the thermal grease
layer on top of the heat sink.
If you did not receive a replacement heat sink with your processor kit,
do the following:
• Using a clean lint-free cloth, remove the thermal grease from the
heat sink removed from the old processor.
• Open the grease packet included with your processor kit and apply
thermal grease evenly to the top of the new processor (see
Figure 3-27).
118
Installing System Components
Positioning the processor incorrectly can permanently damage the
Do not use force to seat the processor. When the processor is positioned
If you did not receive a replacement heat sink, re-use the heat sink