System Battery; Removing The System Battery - Dell PowerEdge HR675 Hardware Owner's Manual

Place the heat sink on the processor (see Figure 3-27).
b
Lower the heat-sink retainers over the edges of the heatsink. One at
c
a time, press the tabs on the retainers down and inward until they
lock into place, securing the heatsink.
8 Replace the processor airflow shroud (see "Installing the Processor Airflow
Shroud" on page 72).
9 Replace the system cover (see "Installing the System Cover" on page 67).
10 Place the system upright on a flat, stable surface.
11 Reattach any peripherals you disconnected, then connect the system to
the electrical outlet.
12 Turn on the system and attached peripherals.
As the system boots, the system detects the new processor and
automatically changes the system configuration information in the System
Setup program.
13 Enter the System Setup program, and check that the processor information
matches the new system configuration (see "Entering the System Setup
Program" on page 41).
14 Run the system diagnostics to verify that the processor operates correctly.
NOTE:
diagnostics (see "Running the System Diagnostics" on page 163).

System Battery

The system battery is a 3.0-volt (V), coin-cell battery.

Removing the System Battery

CAUTION:
Many repairs may only be done by a certified service technician. You
should only perform troubleshooting and simple repairs as authorized in your
product documentation, or as directed by the online or telephone service and
support team. Damage due to servicing that is not authorized by Dell is not covered
by your warranty. Read and follow the safety instructions that came with the
product.
You can test the processor, if desired, by running the system
Installing System Components
119