Minolta MAGICOLOR 2 Manual page 87

Do Sys/Start
Is Password
0?
Default
Chaining
Default Paper
Tray
Number of
Paper Trays
Left Margin
Top Margin
Resolution
Identifies whether the printer controller checks the
hard disk for a PostScript file named SYS\START
and then executes the file. This file does not print.
Configuration Menu: Administration/Startup
Options/Do Sys Start
Identifies whether the Administration menu
password is set.
0=Off
Configuration Menu: Installation/Use Admin Pwd
Identifies whether tray chaining is enabled or
disabled. Tray chaining allows the printer to draw
media from another input source with either the
same or any size and type of media (dependent on
the choice selected) automatically when the first
input source empties.
Configuration Menu: Operator Control/Chain
Inputbins
Tells you which input source is the default.
Configuration Menu: Operator Control/Inputbin
Tells you the number of input sources available on
your printer.
Configuration Menu: No equivalent.
Identifies the amount (in .01" increments) the
image is adjusted horizontally on the page.
Configuration Menu: Administration/Engine/
Image Alignment/Horiz Offset
Identifies the amount (in .01" increments) the
image is adjusted vertically on the page.
Configuration Menu: Administration/Engine/
Image Alignment/Vertical Offset
Identifies the printer resolution.
Configuration Menu: Administration/Engine/Def.
Resolution