Table of Contents
Advertisement
n
Do the printer start-up and status pages list the interface? Is the
configuration information correct?
n
Is the interface enabled?
n
Is the appropriate protocol (or protocols) enabled?
Are all printer and protocol addresses configured correctly?
n
The amount of RAM installed in your printer governs which reso-
lutions can be used with each media size. If you have a QMS
magicolor 2 Print System with
— 24 MB RAM, you can print at 600x600 dpi resolution on all
media sizes.
— 48 MB RAM, you can print at 1200x600 dpi resolution on all
media sizes.
— 88 MB RAM, you can print at 2400x600 dpi resolution on all
media sizes.
Check the start-up page to make sure the printer has enough
RAM installed. See chapter 2, "Memory and System Software," in
the Options manual for information on installing additional RAM.
n
If you have enough RAM installed, and you have configured the
printer from the control panel to print at 600x600, 1200x600, or
2400x600 dpi resolution (Administration/Engine/Def Resolution
menu) but the printer continues printing at a lower resolution, you
may need additional memory allocated to the frame buffer.
To allocate the correct amount of memory, use the Memory/Quick
Config menu to choose the correct resolution and paper size for
your printing. See chapter 4, "Printer Configuration," in the Refer-
ence manual for more information.
Advertisement
Table of Contents
