Minolta MAGICOLOR 2 Manual page 150

If you need to relocate or ship your printer after it's been installed, you
must follow the procedures in this chapter to prevent damage to the
printer and to keep your warranty valid.
s Caution: QMS cannot be held responsible for damage to your printer
during shipment that results from the improper packaging of your
printer. You must use the instructions given in this section before
repacking the printer in its original shipping carton with the original
packing materials.
If you need replacement packaging, in the US call QMS National
Service at 1 (334) 633-4300 x 2530 and request catalog number
2600439-200. If you need to return the printer for service, in the US
call QMS Customer Service at 1 (334) 633-1072 for an RMA (Return
Merchandise Authorization) number before shipping the printer. In
other countries, refer to appendix A, "QMS Customer Support."
Repacking your printer for shipment involves the following steps.
Each is described in more detail in the following sections.
1 Remove the cables and paper cassette.
2 Remove the toner cartridges.
3 Remove the OPC belt cartridge.
4 Prepare the fuser unit for shipment:
5 Change the waste toner pack.
6 Remove the lower input feeder (if attached).
7 Pack the printer for shipment.