Use this procedure when the message window displays
WAITING ON INPUT
END JOB?
Note: This procedure does not end print jobs that are still receiving
»
data. Its only purpose is to provide an end-of-job indicator for a print
job that does not have one. You can identify an end-of-job indicator in
the Administration/Communications/Parallel and Administration/
Communications/Serial menu. (Refer to chapter 5, "Additional
Technical Information," in the Reference Manual for a complete
discussion of End Job Mode.
Press this key...
Cancel
Next (twice)
Cancel or Select
v
to...
Access the Job Cancel menu. JOB CANCEL
Advance to the End Job
mode.
Select End Job.
The message window
reads...
CANCEL JOB
JOB CANCEL
END JOB
END JOB
IS SELECTED