Table of Contents
Advertisement
PROBLEM
The suspend button
does not work
System BIOS cannot
be reprogrammed
START-UP PROBLEMS
The system displays an invalid configuration error message
at power on when there are the following conditions:
current configuration information does not match con-
figuration information stored in Auto Setup, such as
when an internal option is added.
the system loses configuration information.
the lithium battery for the CMOS is depleted.
If any of these conditions is true, the system displays an
"invalid configuration information" message.
To continue start-up procedures, press
Setup to set current system parameters.
Troubleshooting
WHAT TO DO
Power management is disabled in Auto Setup.
A disk drive might be busy. Wait until the disk drive
stops and try again.
The docking station might be connected to the
Versa. Some power management functions do
not work when the docking station is connected.
System Configuration switch 1 may be in the
up position (on). Move switch 1 down and retry
flashing a BIOS.
and run Auto
F1
Problem Solving 6-3
Advertisement
Table of Contents
