NEC VERSA P Manual page 150

FEDERAL COMMUNICATIONS COMMISSION
RADIO FREQUENCY INTERFERENCE STATEMENT
WARNING: Changes or modifications to this unit not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are de-
signed to provide reasonable protection against harmful interference in a residen-
tial installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular in-
stallation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user
is encouraged to try to correct the interference by one or more of the following
measures.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment to an outlet on a circuit different from the one to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
Use a shielded and properly grounded I/O cable to ensure compliance of this unit
to the specified limits of the rules.
FCC Modem Connection Requirements
The Federal Communications Commission (FCC) has established Rules that
permit this device to be directly connected to the telephone network. Standardized
jacks are used for these connections. This equipment should not be used on party
lines or coin lines.
If the modem is malfunctioning, it may also be harming the telephone network.
Disconnect the modem until the source of the problem is determined and repairs
are made. If this is not done, the telephone company may temporarily disconnect
service.
(For United States Use Only)