Table of Contents
Advertisement
Exit
This option will exit the utility and reset the system. Press
to exit the utility. If you press
Enter
to the following appears.
Select the appropriate option.
In high-security environments where you do not want
the BIOS to be easily updated, simply disable the BIOS
reprogramming. This prevents any modification of the
BIOS. You can prevent BIOS reprogramming with System
Configuration switch SW1–1.
Errors and Messages
The following list describes the possible error and warning
messages you might receive when using the BIOS Update
utility.
An error indicating that the system does not contain a
Flash ROM. The utility cannot be used. Be sure that you
powered off the system before loading the BIOS Update
utility. Run Auto Setup to check that your system configu-
ration settings are correct. Or, switch one may not be
turned off. Or, the system was warm booted instead of
cold booted. If you still have a problem, contact techni-
cal support or your NEC dealer for update information.
A message informing you that the system's version of
BIOS cannot be updated by the diskette because it is not
a supported revision. The utility cannot be used. Or,
switch one may not be turned off. Or, the system was
warm booted instead of cold booted. Contact technical
support or your NEC dealer for update information.
C-14 Using the BIOS Update Utility
Return to the Main Menu
Exit this utility
, a message similar
Esc
Advertisement
Table of Contents
