Start-Up Problems - NEC VersaDayLite User Manual

Problem
Information on the LCD is
difficult to see.
An optional component
does not work.
The Power button does
not resume the system
from Standby mode.
The system does not
auto-suspend (Standby).
Upon resuming from a
manual STF the system
displays the message,
"Following system
component(s) changed
since last suspend –
System Memory. Do you
want to (B)oot or (P)ower
down?"

Start-Up Problems

The system displays an invalid configuration error message at power on when there are
the following conditions:
the current configuration information does not match configuration information
!
stored in Auto Setup, such as when an internal option is added.
the system loses configuration information.
!
If either condition is true, the system displays an "invalid configuration information"
message.
To continue start-up procedures, press
utility to set current system parameters.
Note
display on either the LCD or a CRT. The system warns you by beeping.
Resolution
Use the Backlit mode instead of the Reflective mode
when working inside.
Use the Fn-F8 and Fn-F9 functions keys to adjust the
brightness control.
Make sure the component is securely installed or
connected. Verify that the system parameter for the I/O
port configuration is set correctly in Setup.
If system does not resume, it may have auto
suspended (Standby) on a low battery. Attach the AC
adapter and try again.
A disk drive might be busy. Wait until the disk drive
stops and try again.
Power down the system and reseat the memory.
If new memory was installed prior to manual STF,
remove new memory before resuming.
When the NEC Versa detects an error related to display devices, it cannot
Troubleshooting
(or when prompted) and run the Setup
F2 F1
Solving System Problems 10-3