Table of Contents
Advertisement
Using equal pressure at the ends of the cache module,
push it downwards until it is fully seated in the
socket.
Installing the cache module into the socket
Repeat step 3 to install the other four cache modules.
4.
Configure the system for 256 KB of secondary cache by
5.
setting the following jumpers on the system board:
JP16 — set a jumper on pins 2 and 3.
JP17 — set a jumper on pins 1 and 2.
See Chapter 6 to locate and set the JP16 and JP17
Secondary Cache jumpers.
Replace any expansion boards you removed (see "Board
6.
Installation" earlier in this chapter) and reconnect any
cables.
Replace the system unit cover (see Chapter 4).
7.
Adding Options 5-35
Advertisement
Table of Contents
