Table of Contents
Advertisement
Installing a Storage Device in the Desktop
Use the following procedure to install a storage device in
the desktop system.
Follow the preinstallation instructions that come with
1.
your device, such as setting jumpers and switches.
See "Device Preparation" earlier in this chapter for
device preparation information.
NOTE
rails, do not attach them. Remove any rails already
attached. See the documentation that comes with
the device.
Remove the system unit cover (see Chapter 4).
2.
power is off and the system and its peripherals
are unplugged before you begin the installation
procedure.
3.
Remove the 3 1/2-inch drive bracket containing the
standard 1.44-MB diskette drive and hard disk as
follows.
5-56 Adding Options
If your 5 1/4-inch device comes with drive
!
WARNING: Be sure that the system
Advertisement
Table of Contents
Need help?
Do you have a question about the PowerMate V486 Series and is the answer not in the manual?