Table of Contents
Advertisement
9.
Replace the 3 1/2-inch device bracket in the 3 1/2-inch
device slot. Take care to prevent pulling and loosening
cable connections.
Secure the device bracket in place with the four screws
you removed earlier.
If you installed a 1.2-MB diskette drive, remove the
10.
protective cardboard insert from the drive.
Replace the system unit cover (see Chapter 4).
11.
Be sure that you do not pinch any cables or wires when
you replace the cover.
12.
Connect external peripherals and power cables.
13.
Run the Setup program to set your new configuration
(see Chapter 2).
5-64 Adding Options
Securing the 3 1/2-inch drive bracket
Advertisement
Table of Contents
