Table of Contents
Advertisement
T
Set the voltage switch correctly for your area. The correct
setting for the U.S. and Canada is 115V.
Set the voltage switch correctly for your area.
T
Connect the power cable to the system power socket at the
rear of the system unit. Connect the other end to a surge
protector (recommended) or a properly grounded wall
outlet.
NEC CSD recommends connecting the power
cable to a surge protector.
Startup
Press the power button to start up the system. The power
lamp lights green to indicate that the system is on. The NEC
startup screen appears.
At the bottom of this screen, messages like the following
appear:
Press <F2> key if you want to run Setup
Press ESC to display POST
2-4 Setting Up the System
!
WARNING
! CAUTION
Advertisement
Table of Contents
