Nitsuko 1232 Instruction And Installation Manual page 35

Installation of 3SMDR and Printer/PC
3. After installing the 3SMDR unit, connect the printer/PC and the main equipment using a RS232C
cable.
4. Set the SW1 on the 3SMDR unit to the proper bit rate position.
5. Set the interface conditions of the printer/PC as follows:
Ÿ Word length:
7 bit
Ÿ Parity bit:
Even parity
Ÿ Start bit:
1 bit
Ÿ Stop bit length: 2 bit
6. Put the housing and cover back and secure the screws.
7. Plug the AC cord into an AC outlet,
Note: If the 3DHEXU unit has been installed in the main equipment, remove the 3DHEXU unit from
the main unit and install the 3SMDR unit first. Then mount the removed 3DHEXU unit on the
SMDR unit.
NX7E-3SMDR-A1 unit
SW1
¾ 3-1-6 ¾
Removing the knock-out
panel.
To printer