Nitsuko 1232 Instruction And Installation Manual page 236

Program 85
This program assigns the extension ports connected to NVM (Nitsuko Voice Mail) on TX-Z
1232/2464.
Display Indication
V O I C E M A I L P O R T
# # # # # 8 5 # # # # #
TX-Z 1232/2464 Only
Program 87
This program determines how long after seizing a Trunk line a user must wait before the line can be
placed on hold.
Display Indication
H D D I S A B L E T I M E R
# # # # # 8 7 # # # # #
Program 88
This program allows an automatic Door relay contact timer to be programmed. This will set how long
the relay timer will stay contacted once activated.
Display Indication
D O O R # R E L A Y
# # # # # 8 8 # # # # #
Program 89
This program assigns the delay required from the point of seizing a Trunk line to the point where the
system dials the digits entered by the end user. This timer should be longer than the first dial waiting
timer of CO line's specification.
Display Indication
D I A L # W A I T # #
# # # # # 8 9 # # # # #
NN. 01 - 08
ST. 00: Not Connected
10 - System Max: Extension Port No.
N N - S T
TTT. Hold Disable Timer
000: Can hold immediately
001 - 255: 1 - 255 s
- T T T
TTT. Time for Relay contact
# T I M E R
000: Unlock/Lock by manual
001 - 255: 0.1 - 25.5 s
- T T T
(Locked after assigned timer is over.)
TTT. Pre-pause timer for outside dial
T I M E R
000 - 255: 0 - 25.5 s
- T T T
¾ 5-39 ¾
Input Data
Input Data
Input Data
Input Data
Initial
(NN = 01 -
08)
ST: 00
Initial
TTT: 000
Initial
TTT: 000
Initial
TTT: 008