BWT AQA drink Operating Instructions Manual page 48

Until the boiler has not reached the appropriate temperature, the light on the selection button for 'Hot water'
flashes.
While the boiler is automatically venting (also during the1st start-up), all water options symbols (see Fig. 7)
and the first selection button for hot water
can be drawn.
5.12 DRIP TRAY & WASTEWATER TANK
Drip tray
The drip tray catches any spillages when you draw water and must be emptied and cleaned regularly (see
chapter 6 "Hygiene & cleaning").
The drip tray icon -
when the drip tray is full. The light of the selection buttons goes off and no water can be drawn until the drip
tray is emptied.
If the icon flashes red and an acoustic signal sounds until any button is pressed, a leakage is detected.
An Aquastop protects the appliance from further water leakage.
Note!
Any condensation water from the boiler is collected in the drip tray. This allows water to collect in the drip
tray even when the dispenser is not in use.
As the drip tray can only contain a limited volume of water, no cups or glasses should be emptied in it.
Otherwise there is a risk of overflowing it.
Wastewater tank (only available for stand-alone units)
On stand-alone units, the drip tray can be connected to a wastewater tank. This is located inside the base
cabinet. As soon as it is full, the icon
twice. No water can be drawn until the wastewater tank is emptied.
6. HYGIENE & CLEANING
For perfect hygiene, the water dispenser should be maintained at regular intervals by a responsible and
trained person. The hygiene interval depends on the intensity of use and the installation site. We recommend
regular cleaning (see chapter 6.1). For your safety and that of your customers, we recommend that you
document the care and hygiene work carried out in a hygiene log. A copy is enclosed at the end (chapter 11)
of these operating instructions.
EN
Note!
Wear hygienic gloves during cleaning.
If any damage or leaks are detected during cleaning, immediately close the water supply, disconnect it from
the power supply and contact a service technician.
Do not use a waterjet to clean the machine.
Use a soft cloth such as microfibre for cleaning.
46
flash. All other selection buttons are not illuminated. No water
- on the control panel flashes blue and an acoustic signal sounds twice
on the control panel flashes blue and an acoustic signal sounds