BWT AQA drink Operating Instructions Manual page 37

Fig. 7: Control panel AQA drink Pro 60 HOT
Description of the LED icons:
UV: when the UV reactor is operating, the icon on the control panel lights blue until the water
output is finished. A red flashing light indicates a fault in the UV reactor.
Filter status indicator: the icon on the control panel lights up during each water delivery.
Depending on the colour, it indicates the status of the filter capacity:
- pink light: filter ok
- blue/red flashing: filter capacity low (< 20%), replacement soon necessary
- red light: filter capacity is exhausted - filter must be replaced
Drip tray: this icon lights up when either the drip tray/wastewater tank are full or a leakage has
been detected:
- blue flashing: Drip tray/wastewater tank full
- red flashing: Leakage detected
NFC: sensor for touchless water withdrawal via the BWT Home APP:
- blue light: in standby mode
- pink light: NFC data transfer accomplished
Note!
Filter indicator: if water is drawn when the filter cartridge is exhausted, the symbol lights up red while water is
being drawn. An acoustic signal sounds at the end of the dispensing process.
When the function is idle, the LED icons are not visible. They only light up when the respective function is
activated.
1. Water options symbols
hot
ambient, still
cooled, still
cooled, sparkling
2. Selection button
3. LED icon for UV reactor
4. LED icon for filter status
5. LED icon for drip tray/leakage
6. NFC
EN
35