BWT AQA drink Operating Instructions Manual page 44

5.6 WATER CONNECTION
Caution!
When installing accessories (hoses, connection kits), observe the installation dimensions and bending radii.
A new connection kit (connection pieces, seals and hoses) must be used to connect the device to the water
supply. Do not use a used connection kit!
To connect the device, use only hoses that comply with DVGW W 543 (DVGW - German Technical and
Scientific Association for Gas and Water).
» Install a shut-off valve
» Properly install the pressure reducer, water stop and water filter (see chapter 5.8 "Installing the filter") and
connect the cold water pipe to the water dispenser (WATER INLET).
» Set the pressure reducer to 4 bar.
» Open the shut-off valve.
» Now connect the unit to the mains supply and switch the unit on. An acoustic signal is emitted.
» Unit automatically checks whether there is sufficient water pressure. If not, the backlight of the control
panel flashes and the illumination of the selection buttons remains off.
» The appliance automatically checks the filling level of the boiler. If the boiler has not been filled
completely, only the hot water
an acoustic signal sounds. The boiler starts to heat up. The selection button for hot water flashes - the
faster it flashes, the colder the boiler is. When the set temperature is reached, the selection button is
permanently lit (only Pro 60 HOT).
» The unit starts to cool. Until the temperature in the cooler has not been reached, the light of the selection
button for cooled, still water
» If a BWT CO
CO gas cylinder is empty or not connected, the selection button for cooled, sparkling water
2
light up and it is not possible to draw sparkling water.
» Press the still water selection button
» Press the selection button for cooled, still water
» Press the selection button for cooled, mildly sparkling water
60 only).
» Press the selection button for cooled, sparkling water until water flows from the water outlet.
» Disinfect the system (see chapter 6.2, "Cleaning & Disinfection").
» Check the machine for possible leaks.
» Full cooling and heating capacity is reached when the selection button for cooled, still water stops
flashing, takes approx. 20 min. The unit is now ready for use.
5.7 SETTING WATER TEMPERATURE
The AQA drink Pro 60 water dispenser enables individual setting of the cold and hot water temperatures (hot
EN
only with Pro 60 HOT).
The setting itself can only be done by qualified personnel via the BWT Professional App (see chapter 5.1).
The following temperature settings are possible:
Cold water
- very, very cold water (~ 4 °C)
- very cold water (~ 7 °C)
- cold water (~ 10 °C)
42
D (Fig 1) before the device.
-selection button lights up, all others are not backlit. Draw hot water until
pulsates .
monitor is used, the unit automatically checks the content of the CO
2
until water flows from the water outlet.
until water flows from the water outlet.
until water flows from the water outlet (Pro
Hot water (Pro 60 HOT only)
-85 °C
-95 °C
- 98 °C
gas cylinder. If the
2
does not