• Depending on the materials to be processed, this may require the construction of a dedicated
ventilation system.
• The location should be away from children; combustible, flammable, explosive, or corrosive
materials; and sensitive EMI machines.
• The two power cords should be plugged into a compatible and stable power source via
grounded 3-prong outlets on SEPARATE circuits rated for at least 10 A.
• The location has fire-fighting equipment nearby and the local fire department's phone number
clearly displayed.
• It is recommended to use a windowless room or to use blinds and/or curtains to avoid exposure
to the potential additional heat of direct sunlight.
• It is highly recommended to have an extra work table nearby to avoid placing objects on or
directly adjacent to the machine, which could become a fire or laser hazard.
3.3 Unpacking Your Engraver
Your engraver should have arrived in a wooden crate with its accessories (including this manual)
packaged inside. You should place the crate in a spacious flat area for unpacking, ideally near where
you plan to operate the machine permanently. Use at least two people to move and adjust the
engraver's position to help keep it level and avoid any sharp or sudden movement.
1.
Open the top of the crate.
2. Carefully remove the packaging and foam insulation from the sides and set them aside. With
at least one other person, use the two straps around the engraver to lift it out of the crate and
move it to a sturdy table or countertop.
3. Carefully remove the straps and plastic packaging from around the engraver.
4. Open the cover and take out all the parts.
Make sure that you have received all listed accessories in the package list (see
List
on Page 9.
5. Carefully remove any remaining interior packaging and stays—including the strap around the
laser head—and set them aside.
The laser tube is a highly fragile object and should be handled delicately and as little as possible.
You may keep the packaging in case of future return but, if you dispose of it or any accessories, be
sure to do so in compliance with applicable waste disposal regulations.
26
§ 2.4.1 Package
Need help?
Do you have a question about the SH-G1060 and is the answer not in the manual?