General Safety Instructions - Omtech SH-G1060 User Manual

1 Safety Information

1.3 General Safety Instructions

• Your device should come with instruction labels in the following locations:
If any of these labels is missing, illegible, or becomes damaged, it must be replaced.
• Use this laser engraving device only in accordance with all applicable local and national laws and
regulations.
• Use this device only in accordance with this instruction manual and the manual for the engraving
software included with it. Only allow this device to be installed, operated, maintained, repaired,
etc. by others who have also read and understood both manuals. Ensure that this manual and
the software manual are both included with this device if it is ever given or sold to a third party.
• DO NOT operate continuously for more than 5½ hours. Stop for at least 30 minutes
between uses.
• DO NOT leave this device unattended during operation. Observe the device
throughout operation and, if anything seems to be operating strangely, immediately
cut off ALL power to the machine and contact either our customer service or your
dedicated repair service. Similarly, ensure the device is FULLY turned off (including by
means of the emergency stop switch) after each use.
SH-G1060 1000*600mm
100W CO
2
110-120 V
USB-1006-US
3