Pre-Operation Preparation; Turning On The Machine - Omtech SH-G1060 User Manual

4.2 Pre-Operation Preparation

4.2.1

Turning on the Machine

1. Make sure the power supply is ok.
2. Turn on your water cooling system.
3. (Optional) Turn on your additional ventilation system (such as a dedicated purifier).
4. On the control panel, slightly rotate the
emergency stop button counterclockwise
until it pops up.
5. Turn on the main power by pressing the
main power button.
6. Use the laser key to activate the laser
source.
7. Open the engraver's cover to check that the air assist is working properly. Close the cover.
8. Wait until the engraver is in standby mode and ready to use.
6
44
4
5