Cleaning The Main Bay And Engraver - Omtech SH-G1060 User Manual

5 Maintenance

5.2.2 Cleaning the Main Bay and Engraver

Cleaning Frequency: Daily, after each use
• Disconnect the engraver from power before cleaning.
• Completely wipe dry the surfaces after cleaning.
• NEVER allow water to come into contact with the electronic elements.
Depending on what you've been engraving, you might need to clean the
engraver more or less often. However, we suggest cleaning it after each use for
the best results.
Tools Needed:
• Paper towel
• Mild detergent
Viewing Window
Clean with mild cleansers and a lens or cotton cloth. DO NOT use paper towels as they can scratch
the acrylic and reduce the cover's ability to protect you from laser radiation.
Main Bay Interior
Clean thoroughly with paper towels, removing any debris or deposits.
Debris Tray
1. Open the front access door (using the key if you have locked it).
2. Take out the debris tray.
3. Empty loose waste, rinse dust and fine debris off and dry it.
4. Replace the debris tray.
Other Surfaces
Dust the other surfaces with a soft cloth or clean them using a mild detergent and then wipe clean
before further use.
69