General Safety Instructions - Omtech POLAR+ User Manual

55w co2 desktop laser engraver
Table of Contents

Advertisement

1 Safety Information

1.3 General Safety Instructions

• Your engraver should come with instruction labels in the following locations.
If any of these labels is missing, illegible, or damaged, it must be replaced.
• Use this laser engraving engraver only in accordance with all applicable local and national laws
and regulations.
• Use this engraver only in accordance with this instruction manual and the manual for the
engraving software included with it. Only allow this engraver to be installed, operated,
maintained, repaired, etc. by others who have also read and understood both manuals. Ensure
that this manual and the software manual are both included with this engraver if it is ever given
or sold to a third party.
Use of controls or adjustments or performance of procedures other than those
specified herein may result in hazardous radiation exposure.
In the United States, the Polar's wireless network is a certified transmitter module that emits
radio signals in compliance with 47 CFR 15 for commercial locations but may require operators
to provide additional equipment in residential areas to avoid interfering with emergency and
FCC licensed broadcasts. Similarly, the Safe Use of Lasers (Z136) standards published by
the American National Standards Institute do not have the force of law, but adherence to its
provisions may be required by some companies or local authorities to minimize risk and liability.
In particular, it may be necessary in commercial settings to formally designate a laser safety
officer, to post warning signs in areas with active lasers, and to document that all operators of
laser equipment have been properly trained.
3

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the POLAR+ and is the answer not in the manual?

Table of Contents