Flashforge Finder 2.0 User Manual page 63

● After finishing transferring, the printer will heat up automatically. And when heating
finishes, the print will start to build the model.
7.2.3 Print from USB Flash Disk
①Insert your USB flash disk with target .g or .gx file to your Finder2.0. .
②Turn on the Finder2.0. Make sure the build plate has been leveled and the filament is
loaded.
[Print]
and then tap the
③Tap
displayed on the screen. Select the file you want to print and tap [Print]. The file will
be transferred to the printer.
⑥And the printer will heat up the nozzle automatically and start to print after the
nozzle reaches the aimed temperature.,
Abort：To stop heating and printing. Once you tap [Abort], the process is irreversible.
Pause： To suspend the print job, you can tap it again to resume it. You can use this
function when you want to change the filament halfway.
Finder2.0 User Guide |
www.flashforge.com
7-11
SD Card icon in the middle. The file(s) will be
62
0086-0579-82273989