Download Print this page

Flashforge Finder 2.0 User Manual page 76

Advertisement

b. Bottom Solid Layer: Number of solid layers on the under surface of model.
c. Fill Density: Determines the interior solidity of the model.
d. Fill Pattern: Determines the infill pattern used for the interior of part, Hexagon infill
has higher strength and Line infill take less print time.
e. Start Angle: Angle of the infill's first layer
f. Overlap Perimeter: The overlap width between the infill and the shell.
g. Vase Mode: When enabled, the interior infill and top solid infill will not
printed.(Using this option will force 0% infill with only a single perimeter)
2) Speed
a . Solid Speed: Speed at which the top/bottom parts are printed.
b. Sparse Speed: Speed at which the infill is printed.
3)Combine Infill
a. Maximum Combine Layers: Select the layer amount according to the layer height.
The total height shall not be over 0.4mm.
b. Combine Mode: Including "Sparse and Solid" and "Sparse Only". "Sparse Only"
mode only applies for the inner infill layers.
Finder2.0 User Guide |
www.flashforge.com
8-4
66
0086-0579-82273989

Advertisement

loading
Need help?

Need help?

Do you have a question about the Finder 2.0 and is the answer not in the manual?

This manual is also suitable for:

38-9154