Flashforge Finder 2.0 User Manual page 23

(3-3) Remove the top insert.
(3-4) You will see Quick Start Guide, Service Information Card, mains lead, filament guide tube
and a tool bag( USB stick*1, Allen wrenches*2, unclog tool*1, screwdriver*1, and scraper*1 )
（3-5）Discard the blue tape that holds the flat cable in place. Be careful with the flat cable.
(3-6) Cut off four ribbons that used for fixing the guide rod. Then slide the extruder to make sure
the extruder and the rod are in good condition.
Finder2.0 User Guide |
www.flashforge.com
3-4
3-5
3-6
23
0086-0579-82273989