Flashforge Finder 2.0 User Manual page 47

(6-14) Click[Edit], then you can add or remove a height.
6.2.11 File Menus
①New Project
Click [File]--[New Project]
modification on previous project, then it will inform you whether the modification
needs to be saved or not. Click
abandon it. If click [Cancel]
②Saving
After finishing the model edit and adjustment, there are two ways below to save all
models in the scene.
Method 1:
[File]--[Save Project]
Click
".fpp"suffix, all models in the scene (include support) are independent . After
reloading the files, extruder configuration information and model position will be the
same as the configuration during saving.
Finder2.0 User Guide |
www.flashforge.com
6-14
can build a blank project. If there is an unsaved
[Yes] will save the modification, click
or close tool tip, then will cancel the new project.
6-15
in the menu bar to save the file as a project file with the
46
[No] will
0086-0579-82273989