Flashforge Finder 2.0 User Manual page 31

(5-2) After tapping [Yes], the extruder starts to move towards the first point and the
plate moves up and down to verify the distance between nozzle and plate.
(5-3) When it shows that the distance is too small, please screw corresponding nut
under platform counterclockwise; When it shows that the distance is too big, please
unscrew corresponding nut under platform clockwise;
Until hearing a steady beep and the [Verify] button appears.
(5-4) If the distance is appropriate, tap [OK] to second point leveling. If still not,
please follow the prompts to adjust again till you see [OK] button.
(5-5) Repeat steps 2 through 4 above to complete second and third points leveling and
then Tap [Finish] to exit.
Finder2.0 User Guide |
www.flashforge.com
5-3
5-4
5-5
30
0086-0579-82273989