Flashforge Finder 2.0 User Manual page 43

the type of existing support, and will pop up the corresponding prompt to let you make
the choice.
②Auto Supports
Click the [Auto Supports]
are needed and generate corresponding treelike or linear supports. If it is a model with
supports, the existing supports will be deleted and new supports will be generated.
③Add Supports
Supports will be added once clicking the
position where supports needed, left-click to choose the starting point of supports, hold
down the left mouse button and drag the mouse the supports preview will show up(if
support surface doesn't need support or the support column angle is too large, will
highlight the support review ). Loosen the left mouse button, if support column
doesn't meet with model, then support will be generated on origin and terminal
point(the highlighted preview support won't generate support structure )
Finder2.0 User Guide |
www.flashforge.com
6-11
button, the software will judge the position where supports
[Add]
42
button. Move the cursor to the
0086-0579-82273989