Flashforge Finder 2.0 User Manual page 54

②Disconnect Finder2.0
[Print]--[Disconnect]
Click
6.2.14 Tool Menus
①Control Panel
After connecting PC with Finder2.0, click
control panel.
● Jog Controls
a . Jog Mode： Select the distance that extruder/ build plate move a single time (that is,
the distance extruder/ build plate move upon your single click).
b . Six blue arrow direction button: Control the move along X/Y/Z axis. X/Y axis
button control extruder move, Z axis button control build plate move. Click X-,
extruder will move leftward a specified distance; Click X+, extruder will move a
specified distance rightward. Click Y-, extruder will move forward a specified distance;
Click Y-, extruder will move backward a specified distance. Click Z-, build plate will
move upward a specified distance; Click Z-, build plate will move downward a
specified distance. (Specified distance refers to the move distance you set in Jog Mode.
Finder2.0 User Guide |
www.flashforge.com
to disconnect your PC and Finder2.0.
[Tools]--[Control Panel]
6-23
53
to open the
0086-0579-82273989