Flashforge Finder 2.0 User Manual page 51

Method 1：Connect Via USB Cable
a. Connect your Finder2.0 with your PC via an USB cable.
b. Turn on your Finder2.0 and start Flashprint.
c.Click [Print]--[Connect
option and select machine you want to connect in
not find your machine, click the
Finally click [Connect]
machine after rescan, it means you haven't installed the driver in the software.
Method 2： Connect Via WIFI
①Connect Finder2.0 with your PC under AP mode
Turn on your Finder2.0
a.
Tap [Tools]-[Setting]-[WIFI]-[WIFI ON]
b.
Click on the wireless network on the left bottom, and find the wireless signal-
c.
"Finder2.0". Click [Connect] to finish network connection.
Click[Print]-[Connect Machine] on Flashprint. Then the following dialog box
d.
pops up. You need to select "Wi-Fi" in Connect Mode. Enter into the IP Address
shown on the interface and then click [Connect].
Finder2.0 User Guide |
www.flashforge.com
Machine], then select USB in the
[Rescan]
button to scan your machine and select it.
button to connect to the printer. If you still can not find your
6-18
50
[Connection Mode]
[Select Machine]
option. If you can
0086-0579-82273989