Flashforge Finder 2.0 User Manual page 28

（4-9）After the extruder's temperature reaches 220℃, the printer will sound a beep to
prompt you to load the filament into the extruder.
（4-10）Insert the filament into the extruder at an upright angle. Then the filament will
be drawn through the extruder. Do not tap [Cancel] until the filament load the extruder
steadily.
4.4 Unloading Filament
(4-11) Tap [Tool]-[Unload] and the extruder starts heating up.
Finder2.0 User Guide |
www.flashforge.com
4-9
4-10
4-11
28
0086-0579-82273989