Installing The Optical Drive - Dell PowerVault DL2000 Hardware Owner's Manual

4 Disconnect the optical drive cable from the back of the drive.
5 To remove the optical drive, press down and forward on the blue tray
release tab and slide the drive tray out of the system. See Figure 3-17.
Figure 3-17. Removing and Installing the Optical Drive Tray
optical-drive cable
1
optical -drive tray
3

Installing the Optical Drive

1 Insert the optical drive tray into the system until it is fully inserted and
locked into position.
2 Connect the SATA cable (the end with the branching power cable) to the
back of the optical drive.
3 Connect the branching power cable to the power supply connector.
4 Remove the cooling shroud. See "Removing the Cooling Shroud" on
page 80.
4
3
optical-drive release tab
2
optical drive
4
Installing System Components
1
2
97