Dell PowerVault DL2000 Hardware Owner's Manual page 111

Figure 3-22. Replacing the System Battery
1 positive side of battery connector
3 negative side of battery connector
NOTICE:
To avoid damage to the battery connector, you must firmly support the
connector while installing or removing a battery.
5 Install the new system battery.
Support the battery connector by pressing down firmly on the positive
a
side of the connector.
Hold the battery with the "+" facing up, and slide it under the
b
securing tabs at the positive side of the connector.
Press the battery straight down into the connector until it snaps into
c
place.
6 Close the system. See "Closing the System" on page 67.
7 Reconnect the system to its electrical outlet and turn the system on,
including any attached peripherals.
8 Enter the System Setup program to confirm that the battery is operating
properly. See "Entering the System Setup Program" on page 45.
9 Enter the correct time and date in the System Setup program's Time and
Date fields.
10 Exit the System Setup program.
1
3
2
2 system battery
Installing System Components
111