Dell PowerVault DL2000 Hardware Owner's Manual page 42

Dell storage system hardware owner's manual
Hide thumbs Also See for PowerVault DL2000:
Table of Contents

Advertisement

Table 1-7. System Messages (continued)
Message
Timer chip counter
2 failed
Unsupported CPU
combination
Unsupported CPU
stepping detected
Utility partition
not available
Warning! No micro
code update loaded
for processor 0
Warning: Embedded
RAID firmware is
not present.
Warning: Embedded
RAID error.
42
About Your System
Causes
Faulty system board.
Microprocessor(s) is not
supported by the system.
The <F10> key was
pressed during POST, but
no utility partition exists
on the boot hard drive.
Micro code update failed. Update the BIOS firmware.
Embedded RAID firmware
does not respond.
Embedded RAID firmware
responds with an error.
Corrective Actions
See "Getting Help" on
page 167.
Install a supported
microprocessor or
microprocessor
combination. See
"Processors" on page 105.
Create a utility partition on
the boot hard drive. See the
CDs that came with your
system.
See "Getting Help" on
page 167.
See the RAID controller
documentation for
information about installing
or updating the RAID
firmware.
See "Troubleshooting a SAS
Controller Daughter Card"
on page 147. See the RAID
controller documentation
for information about
installing or updating the
RAID firmware.

Advertisement

Table of Contents
loading

Table of Contents