Dell PowerVault DL2000 Hardware Owner's Manual page 94

5 Angle the DRAC card so that its NIC connector inserts through the back-
panel DRAC card opening, aligning the card with the back standoff.
Figure 3-16. Installing and Removing a DRAC Card
2
1
1 DRAC-card connectors (2)
3 retention standoff hole
5 filler plug
6 Align the front edge of the DRAC card with the two front plastic retention
standoffs adjacent to the DRAC system board connector, and press down
the side of the card until it is fully seated. See Figure 3-16.
When the front of the card is fully seated, the front plastic standoffs snap
over the front edge of the card.
94
Installing System Components
3
2 DRAC-card cables (2)
4 DRAC card
6 support standoffs holes(2)
4
5
6